To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...How to restart Siemens Synco 700 when it's locked in remote operation?
If your Siemens Controller is displaying 'Operation locked Remote operation' and is completely switched off, and restarting via remote operation isn't working, disconnect the controller from power briefly to restart it locally. This issue occurs because remote operation has set the controller to commissioning mode, disabling local operation.
How to change the language on a Siemens Synco 700?
If you selected the wrong language during the initial setup of your Siemens Controller, press the ESC button and the OK knob simultaneously. Then, select the password level and enter '112' as the password (same as international emergency call) and confirm by pressing the OK knob. The language will change to English, and you can select your preferred language from the Settings > Device > Language menu.
General| Display | LCD |
|---|---|
| Product type | Controller |
| Operating voltage | 24 V AC |
| Communication | KNX |
| Power Supply | 24 V AC |
Overview of the controller's buttons, screen, symbols, and basic interface.
Instructions for navigating through menus and selecting options.
Procedure for initial heating setup and programming room heating schedules.
Setting and adjusting room temperatures based on operating modes and setpoints.
Controlling DHW heating, temperature setpoints, and time programs.
Setting system time, date, and configuring special or holiday periods.
Viewing detailed system status, data, and boiler information.
Procedures for identifying, acknowledging, and resolving system faults.
Guidance for diagnosing and resolving common operational issues.
Tips for reducing energy consumption while maintaining comfort.
