TC35i: Migration from TC35 to TC35i
PRELIMINARY
TC35_TC35i_MIG_01_V01.01 29.1.2003 Page 25 of 34
# AT Command
56 AT+FDFFC Data Compression Format Conversion
57 AT+FDIS Query or set session parameter
58 AT+FDR Begin or continue phase C data reception
59 AT+FDT Data Transmission
60 AT+FET End a page or document
61 AT+FK Kill operation, orderly FAX abort
62 AT+FLID Query or set the Local Id setting capabilities
63 AT+FMDL Identify Product Mode
64 AT+FMFR Request Manufacturer Identification
65 AT+FOPT Set bit order independently
66 AT+FPHCTO DTE Phase C Response Timeout
67 AT+FREV Identify Product Revision
68 AT+FRH Receive Data Using HDLC Framing
69 AT+FRM Receive Data
70 AT+FRS Receive Silence
71 AT+FTH Transmit Data Using HDLC Framing
72 AT+FTM Transmit Data
73 AT+FTS Stop Transmission and Wait
74 AT+FVRFC Vertical resolution format conversion
5.2.3 AT Commands originating from GSM 07.07
Table 5-3: AT commands from GSM 07.07
# AT Command
75 AT+CACM Accumulated call meter (ACM) reset or query
76 AT+CALA Set alarm time
Differing references to URC implementation in autobauding
TC35i
Indicates ME wake-up into Alarm mode:
^SYSSTART ALARM MODE
+CALA: <text>
If autobauding is active (AT+IPR=0) the URCs
^SYSSTART ALARM MODE does not appear but
your individual <text> message will be displayed.
TC35
Indicates ME wake-up into Alarm mode:
^SYSSTART ALARM MODE
+CALA: <text>
If autobauding is active (AT+IPR=0) the URCs
^SYSSTART ALARM MODE
and +CALA: <text> do not appear. Therefore,
avoid using Alarm mode in conjunction with
autobauding.
77 AT+CAMM Accumulated call meter maximum (ACMmax) set or query
78 AT+CAOC Advice of Charge information
79 AT+CBST Select bearer service type
80 AT+CCFC Call forwarding number and conditions control
81 AT+CCLK Real Time Clock
82 AT+CEER Extended error report
83 AT+CFUN Set phone functionality
Differing parameters and notes
To Next Page
Loading...
Need help?
General
