TC35i: Migration from TC35 to TC35i
PRELIMINARY
TC35_TC35i_MIG_01_V01.01 29.1.2003 Page 32 of 34
# AT Command
TC35i
<audioMode>
1 Audio mode 1: Standard mode optimised for the
default handset, that can be connected to the
analogue interface 1 (see your "Hardware Interface
Description" for information on this handset.) To
adjust the volume use the knob of the default
handset. This handset can be used in audio mode 4
with user defined parameters.
Note: The default parameters are determined for type
approval and are not adjustable with AT commands.
TC35
<audMode>
1 Audio mode 1: Standard mode optimised for the
default handset, that can be connected to the
analogue interface 1 (see your "Hardware Interface
Description" for information on this handset.) To
adjust the volume use the knob of the default
handset. In audio mode 4 and 5, this handset can
be used with user defined parameters.
Note: The default parameters are determined for
type approval and are not adjustable with AT
commands.
163 AT^SNFV Set loudspeaker volume
164 AT^SNFW Write audio setting in non-volatile store
Differing implementation and notes
TC35i
ME stores the following audio parameter values in
non-volatile memory:<audioMode>, <inBbcGain>,
<inCalibrate>, <outBbcGain>, <outCalibrate[0]>
... <outCalibrate[4]>, <side Tone>
TC35
Saved parameters: <inBbcGain>, <inCalibrate>,
<outBbcGain>, <outCalibrate[0]> ...
<outCalibrate[4]>, <side Tone>
165 AT^SPBC Search the first entry in the sorted telephone book
166 AT^SPBG Read entry from active telephone book via sorted index
167 AT^SPBS Steps the selected phonebook alphabetically
168 AT^SPIC Display PIN counter
169 AT^SPLM Read the PLMN list
170 AT^SPLR Read entry from the preferred operators list
171 AT^SPLW Write an entry to the preferred operators list
172 AT^SPWD Change password for a lock
173 AT^SSCONF SMS Configuration
174 AT^SSDA Set Display Availability
175 AT^SSYNC Configure SYNC Pin
Differing notes on implementation (references to TC35T) and operating modes
176 AT^STCD Display Total Call Duration
5.3 List of new AT-Commands
This chapter lists only new commands, supported exclusively by TC35i.
5.3.1 AT Commands for SIM Application Toolkit (GSM 11.14)
Table 5-6: AT commands for SAT
# AT Command
1 AT^SSTA Remote-SAT Interface Activation
2 AT^SSTN Remote-SAT Notification
3 AT^SSTGI Remote-SAT Get Information
4 AT^SSTR Remote-SAT Response
5.3.2 AT Commands originating from GSM 07.07
Table 5-7: AT commands from GSM 07.07- new
# AT Command
5 AT+CCWA Call waiting
6 AT+CCUG Closed User Group
7 AT+CMER Mobile Equipment Event Reporting
To Next Page
Loading...
Need help?
General
