Parameterization 05.2006
6SE7087-2JD60 Siemens AG
8-22 Operating Instructions SIMOVERT MASTERDRIVES
8.5 Parameter input via the OP1S
The operator control panel (OP1S) is an optional input/output device
which can be used for parameterizing and starting up the units. Plain-
text displays greatly facilitate parameterization.
The OP1S has a non-volatile memory and can permanently store
complete sets of parameters. It can therefore be used for archiving sets
of parameters, but first the parameter sets must be read out (upread)
from the units. Stored parameter sets can also be transferred
(downloaded) to other units.
The OP1S and the unit to be operated communicate with each other via
a serial interface (RS485) using the USS protocol. During
communication, the OP1S assumes the function of the master whereas
the connected units function as slaves.
The OP1S can be operated at baud rates of 9.6 kBd and 19.2 kBd, and
is capable of communicating with up to 32 slaves (addresses 0 to 31). It
can therefore be used in a point-to-point link (e.g. during initial
parameterization) or within a bus configuration.
The plain-text displays can be shown in one of five different languages
(German, English, Spanish, French, Italian). The language is chosen by
selecting the relevant parameter for the slave in question.
Components Order Number
OP1S 6SE7090-0XX84-2FK0
Connecting cable 3 m 6SX7010-0AB03
Connecting cable 5 m 6SX7010-0AB05
Adapter for installation in cabinet door incl. 5 m cable 6SX7010-0AA00
Order numbers
To Next Page
Loading...
Need help?
General
