92
12 Radio (Tuner) Mode
12.1 Selection of the radio station
Turn on the SilverCrest CRB-532 Bluetooth car radio with the “PWR/MUTE” button . If the device was turned off while it was in
RADIO mode, the last selected station will be heard. If the device is set to an operation with one of the different data storage
media, press the “MODE” button
until you reach the radio function.
12.2 Select the wavelength range
FM (VHF) range: To select the FM range, briefly press the “BAND” button repeatedly until the desired range “FM 1”, “FM 2”
or “FM 3” and the current frequency appear on the display.
AM (MW) range: To select the MW range, briefly press the “BAND” button
repeatedly until the display indicates “MW 1” or
“MW 2” and the current frequency.
Note:
After selecting a range, the station last selected in this range will be heard.
12.3 Find and save radio stations
Search for a station with the station search function
To select the stations, select the desired wave band with the “BAND” button (section 13.2). In order to begin searching in the
desired direction, briefly press one of the buttons
or . The scanner will stop at the next available station.
Manual search for a station
In order to select a station manually, press the buttons or for about three seconds. The display will indicate
“MANUAL”. Now press the buttons
or until the desired frequency appears on the display. The frequency will change
in 50kHz increments in the FM range. If there is no entry for about 7 seconds, the device will switch back to automatic station
search. The display will indicate “AUTO”.
To Next Page
Loading...
Need help?
General
