107
English
16 Settings
16.1 Menu level 1
By briefly pressing the volume control dial once or several times, the functions of menu level 1, volume control, bass setting,
treble setting, and the speaker balance between the left and right as well as front and rear speaker groups can be selected and
set.
Changing the bass setting (BASS)
By pressing the control dial twice, you access the bass settings. The message “BAS” will appear on the display together with
the current level (e.g. “+2”). To change the bass bandwidth, turn the control dial
clockwise or counter-clockwise. The
bandwidth can be set in a range between “-7” and “+7”. It can be changed in increments of one. The setting is saved either
when the desired value is confirmed by pressing the control dial
or through automatic storage (do not change anything on the
device for approximately five seconds). If you confirm the selection by pressing the control dial
, you then advance to the next
possible setting. If you use automatic storage, the device will return to the standard display.
Changing the treble setting (TREBLE)
After pressing the control dial three times, the treble setting (TREBLE) can be adjusted. The message “TRE” will appear on
the display together with the current level (e.g. “0”). To change the bandwidth of the treble, turn the control dial clockwise or
counter-clockwise. The bandwidth can be set in a range between “-7” and “+7”. It can be changed in increments of one. The
setting is saved either when the desired value is confirmed by pressing the control dial
or through automatic storage (do not
change anything on the device for approximately five seconds). If you confirm the selection by pressing the control dial
, you
then advance to the next possible setting. If you use automatic storage, the device will return to the standard display.
Change in the volume ratio between the right and left speaker group (BALANCE)
After pressing the control dial four times, the settings for the ratio between the speakers connected on the right and left can
be adjusted (BALANCE). The message “BAL” appears on the display along with the settings for the volume ratio between the
right and left speaker group (e.g. “BAL 2R”). To change the ratio between the speakers, turn the control dial
clockwise or
counter-clockwise. Depending on the direction in which the control dial is turned, an “R” (right speaker group) or an “L” (left
speaker group) will appear on the display, together with a digit (e.g. “2R” or “4L”). These provide information about the direction
in which the volume ratio is changed and also the extent of the change. The ratio between the right and left speaker group can
be set in a range between “8R” and “8L”.
The volume ratio between the speakers changes according to the setting and the volume will increase on one side according to
this setting and decrease on the other side.
To Next Page
Loading...
Need help?
General
