74
7 Installation
7.1 Installing the device
Note:
Please observe the following safety instructions for the connection of the device:
Read the entire installation section before connecting the device.
Disconnect the negative pole of the vehicle battery for the duration of the installation.
Observe the vehicle manufacturer’s safety instructions during this task.
If you need to drill holes for the installation, make sure that no parts of the vehicle are damaged.
The cross section of the plus and minus cable must not be less than 2.5 mm².
Do not connect any plugs or cables from the vehicle to the radio without appropriate expertise!
To connect the device, use only the cable supplied.
Depending on the design layout of your vehicle, the installation may deviate from this description.
We do not assume any liability for damage caused by faulty installation or connection or any damage arising therefrom.
To Next Page
Loading...
Need help?
General
