102
14.2 Selecting a USB storage medium as data source
To play back audio tracks from a storage medium (e.g. USB stick, 2.5-inch USB hard drive) connected to the USB connection,
press the “MODE” button
to select “USB” as the data source.
Then the device will read the audio tracks that can be reproduced from the data storage medium and begins to play back the
first track.
Note:
The “USB” programme source can only be selected through the “MODE” button if a USB storage medium has been
connected to the device.
When you detach the USB storage medium or the plug of the USB connection cable from the device, the device
automatically switches back to the most recently selected programme source.
Please note that only those USB storage media are recognised that have been formatted and written according to the
FAT16 or FAT32 standard. Hard drives formatted in NTFS or Linux are not recognised or supported.
14.3 Selecting an iPod
®
as data source
To select an iPod
®
as the data source, connect it with the iPod
®
connection cable to the USB connection of the device. The
audio data stored on the iPod
®
can now be played in the same way as on the regular USB storage media.
Note:
Please note that the memory of an iPod
is differentiated into two different memory levels. The CRB-532 can only play back
data from the mass storage level. The iTunes
®
level is not supported.
To Next Page
Loading...
Need help?
General
