Silvercrest SCW 5 A2 - Taking Pictures; Burst Mode; Time-Lapse Mode

SilverCrest SCW 5 A2
English - 29
 Press the record button [9] to start recording. During recording the status LEDs [3, 11
and 15] will flash red and the status LED [6] orange.
 Press the record button [9] again to stop recording. The status LEDs [3, 11 and15] go
off.
Taking pictures
 Press and hold the On/Off/Mode button [2] for at least 3 seconds to switch the
camcorder on. The camcorder initialises in Video mode automatically.
 To switch to Photo mode (PHOTO), press the On/Off/Mode button [2] once.
 Press the record button [9] to take a picture. While saving the status LED [3] goes green.
Burst mode
 Press and hold the On/Off/Mode button [2] for at least 3 seconds to switch the
camcorder on. The camcorder initialises in Video mode automatically.
 To switch to Burst mode (BURST), press the On/Off/Mode button [2] three times.
 Press the record button [9] to take a series of 10 pictures. While saving the status LED
[3] goes green.
Time-lapse mode
 Press and hold the On/Off/Mode button [2] for at least 3 seconds to switch the
camcorder on. The camcorder initialises in Video mode automatically.
 To switch to Time-lapse mode (LAPSE), press the On/Off/Mode button [2] four times.
 Press the record button [9] to start recording. During recording the status LEDs [3, 11
and 15] will flash red and the status LED [6] orange.
 Press the record button [9] again to stop recording. The status LED [3] goes off.