■ 8
│
GB
│
IE
SPM 2000 F3
Handling and operation
This section provides you with important information on handling and using the
appliance.
Before initial use
1) Clean all accessories as described in the section “Cleaning and care” to
remove any possible production residues.
2) Read these operating instructions carefully.
3) Set up the appliance in accordance with the safety instructions.
4) Open the safety catch 4 by moving the slider from the
position to the
position.
5) Clean the appliance with a damp cloth as described in “Cleaning and Care”.
6) Close the appliance.
7) Insert the mains cable plug in a properly connected and earthed mains
power socket which supplies the voltage stated in the”Technical data”
section.
8) Allow the appliance to heat up to its maximum temperature for approx.
5 minutes. To do this, turn the dial 1 to “Max”. In the front area of the
dial 1, the marking shows you the set position.
NOTE
►
The first time the appliance heats up, a small amount of smoke and odour
may be generated due to production-related residue. This is normal and is
completely harmless. Provide sufficient ventilation; for example, by opening
a window.
9) Turn the dial1 to position “0”.
10) After heating, pull the plug out of the mains socket and allow the appliance to
cool down completely.
11) Clean the appliance again with a damp cloth.
To Next Page
Loading...
Need help?
General
