4 - 3
4 Adjustments
Drive System
DRIVE SYSTEM
Cruise Control Lever Tension Adjustment
If the cruise control lever will not hold ground speed,
perform the following adjustment.
1. Locate the cruise control tension bolt (A, Figure 3).
2. Tighten the bolt until desired tension is achieved.
DO NOT OVER-TIGHTEN. The brake pedal must be
able to return the cruise control lever to neutral.
Differential Lock Cable Adjustment
1. Locate the adjustment nuts (A, Figure 4) on the for-
ward cable shroud located under the left foot rest.
2. Loosen the adjustment nuts so that the cable is slack
and the foot pedal rod (B) drops down.
3. Tighten the cable until the foot pedal just touches the
upstop (C). There MUST be some slack in the cable.
Figure 4. Differential Lock Cable Adjustment
A. Adjustment Nuts
B. Foot Pedal Rod
C. Upstop
A
B
C
IMPORTANT NOTE
DO NOT ADJUST THE CABLE
SO TIGHT AS TO REMOVE ALL
CABLE SLACK. This will partially
engage the differential lock and damage
the transmission.
Figure 3. Cruise Control Lever Adjustment
A. Tension Bolt
A
To Next Page
Loading...
Need help?
General
