23
SEW ALONG: Buttonhole Stitch
1. Mark position and length of buttonhole on the fabric. Place the button at
the back of the buttonhole foot.
2. Remove the All-Purpose Foot and attach the Buttonhole Foot (See
Page 26). Pass upper thread through the hole of the foot and bring
thread to the left.
3. Set the stitch selection buttons to 94.
4. Set the Stitch Length to 0.5
5. Place the fabric under the foot so that the center line mark on your
fabric is aligned with the center of the buttonhole foot and that the cross
line mark on the fabric aligns with the center hole of the Buttonhole
Foot. Lower the presser foot.
6. Pull the buttonhole lever all the way down and center it between the
front and back brackets located on the left of the buttonhole foot.
7. Hold upper thread slightly and start to sew until the buttonhole is
completed.
8. Return the buttonhole lever to its original position once all buttonholes
are completed.
START SEWING
Sewing a 1-Step Buttonhole
→
Use a stabilizer to support the stitches.
→
Slightly reducing your upper tension by 1 or 2 numbers will improve results.
→
Always test sew on a scrap piece of your fabric.
→
When sewing an innite buttonhole, do not lower the buttonhole lever and select stitches 91 through
93 for the length of buttonhole that you desire.
This machine has an innite buttonhole, as well as 6 built-in buttonholes, allowing you to sew
buttonholes in one easy step. The buttonhole stitches are numbered 91-99.
HOW TO:
1. Set the machine to the desired stitch by entering the number of the desired buttonhole stitch.
(See Page 19)
2. Set the Stitch Length between 0.5 and 0.8. (See Page 19)
Function ButtonsLCD Display
To Next Page
Loading...
Need help?
General
