3
Important Safety Instructions
INTRODUCTION
This household sewing machine is designed to comply with IEC/EN 60335-2-28 and
UL1594.
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic safety precautions should always be
followed, including the following:
Read all instructions before using this household sewing machine. Keep the
instructions in a suitable place close to the machine. Make sure to hand them over if
the machine is given to a third party.
DANGER - To reduce the risk of electric shock :
- A sewing machine should never be left unattended when plugged in. Always
unplug this sewing machine from the electric outlet immediately after using and
before cleaning, removing covers, lubricating or when making any other user
servicing adjustments mentioned in the instruction manual.
WARNING - To reduce the risk of burns, re, electric shock, or
injury to person :
- Do not allow to be used as a toy. Close attention is necessary when this sewing
machine is used by or near children.
- Use this sewing machine only for its intended use as described in this manual. Use
only attachments recommended by the manufacturer as contained in this manual.
- Never operate this sewing machine if it has a damaged cord or plug, if it is not
working properly, if it has been dropped or damaged, or dropped into water.
Return the sewing machine to the nearest authorized dealer or service center for
examination, repair, electrical or mechanical adjustment.
- Never operate the sewing machine with any air openings blocked. Keep ventilation
openings of the sewing machine and foot control free from the accumulation of lint,
dust, and loose cloth.
- Keep ngers away from all moving parts. Special care is required around the
sewing machine needle.
- Always use the proper needle plate. The wrong plate can cause the needle to break.
- Do not use bent needles.
- Do not pull or push fabric while stitching. It may deect the needle causing it to break.
- Wear safety glasses.
- Switch the sewing machine off (“O”) when making any adjustment in the needle
area, such as threading needle, changing needle, threading bobbin, or changing
presser foot, etc.
- Never drop or insert any object into any opening.
- Do not use outdoors.
- Do not operate where aerosol (spray) products are being used or where oxygen is
being administrated.
- To disconnect, turn all controls to the off (“O”) position, then remove plug from outlet.
- Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
- The foot control is used to operate the machine. Avoid placing other objects on the
foot control.
- Do not use the machine if it is wet.
- If the LED lamp is damaged or broken, it must be replaced by the manufacturer or
its service agent or a similarly qualied person, in order to avoid a hazard.
To Next Page
Loading...
Need help?
General
