Ashtray
Fig. 118 Remove / open / disassemble ashtray
Fig. 119
Removing the rear ashtray in-
sert
Read and observe on page 101 first.
Removable ashtray
›
Remove the ashtray in the direction of the arrow
A
» Fig. 118. Insertion
takes place in reverse order.
›
To open the ashtray, turn the cover in the direction of arrow
B
. Closing
takes place in reverse order.
›
To disassemble turn the entire cover in the direction
1
until it stops and re-
move in direction of arrow
2
. Assembling takes place in reverse order.
Ashtray with removable insert
›
To remove the insert, open the ashtray fully, hold the insert in area
C
and
remove in the direction of the arrow » Fig. 119.
Insertion takes place in reverse order.
Cigarette lighter
Fig. 120
Cigarette lighter
Read and observe on page 101 first.
›
To use the lighter, push it in as far as the stop and wait until the glowing
lighter clicks out again » Fig. 120.
›
Take out the glowing lighter instantly, use it and insert it back into the sock-
et.
WARNING
■
The cigarette lighter also works if the ignition is switched off. When leav-
ing the vehicle, never leave people who are not completely independent,
such as children, unattended in the vehicle - there is a risk of burning, fire or
damage to the vehicle interior.
■
Be careful when using the cigarette lighter - it can cause burns.
Note
The cigarette lighter socket can also be used as a 12 volt socket.
Tablet holder
Introduction
External devices (e.g. tablet, smartphone etc.) measuring min. 122 mm and
max. 195 mm can be secured in the holder.
The maximum permissible load of the compartment is 750 g.
CAUTION
Never exceed the maximum permissible load of the holder - there is a risk of
damage or functional impairment.
102
Operation
To Next Page
Loading...
Need help?
General
