How to ensure safety
S
Attention!
If liquids or other non-solid materials are spilled in the X-ray unit or on the feed and discharge con-
veyors, or, if the X-ray unit has got dirty for any other reason, switch the unit off immediately and
disconnect the unit from the mains by unplugging the mains plug in order to avoid damage to the unit
or soiling of the objects to be scanned! If the unit is equipped with a UPS unit, switch it off as well
(F 1-31 "How to switch on") or ensure it is switched off! Make sure the unit remains turned off (e.g.
by removing the mains cable (F 1-28 "How to connect the X-ray unit to the mains") or the key) until it
has been cleaned by a competent service technician! 230
S
Attention!
Items with loose belts or loose packaging and objects which cannot be placed firmly on the convey-
ors as well as all kinds of clothes must be placed into appropriate plastic containers (see below) to
avoid damages! The objects must not move during the inspection. If required, use plastic containers
with structured foam insert!240
S
Attention!
Short or flat items have to be put into plastic containers (see below) to be sure they will be detected
and scanned even if placed in an unfavorable position! Alternatively, the X-ray unit can be operated in
Continuous scanning mode! 250
S
Attention!
Keep in mind that the material and structure of the plastic containers mentioned above may affect
the X-ray unit's material detection characteristics! Inappropriate plastic containers may also cause
electrostatic charging! Therefore, contact your sales partner when choosing suitable plastic contain-
ers. 260
S
Attention!
Do not cover the ventilation openings of the X-ray unit and the monitors! 270
Warning!
Do not look into the laser beam of the bar code scanner* which is available as an accessory and do
not point the beam at other persons! 280
A
Warning!
Observe all warnings and instructions attached to the unit! 290
S
Attention!
Switch the HI-SCAN X-ray unit off by means of the key switch before doing any cleaning and main-
tenance work! You can clean the mechanical parts of the unit by means of a soft, slightly damp cloth
and a gentle cleaner. Do not use chemical cleaning agents because they might damage the unit's
surface and/or labels! 300
95587412 01/01/09 © Smiths Heimann
1-8
To Next Page
Loading...
Need help?
General
