4-8. FL-378 Board
Preparation
1. Remove the top cover. (Refer to “4-2. Top Cover”)
2. Remove the DM shield plate and the FL cover. (Refer to “4-7. TRIAX Connector Assembly”)
Procedure
1. Disconnect the harness from the connector (CN003) on the FL-378 board.
2. Disconnect the coaxial cable from the connector (CN002) on the FL-378 board.
3. Remove the three screws to detach the FL-378 board.
Note
Be sure to hold the plug when disconnecting the coaxial cable. Do not pull the cable.
Hold the plug to connect.
Note for installation
Connecting
connector
CN002
Coaxial cable
CN003
Harness
FL-378 board
PSW
3 x 6
Hold the plug to remove. Do not attempt to remove
by pulling the cable.
NGOK
Note
Hold the plug of the coaxial cable, and connect it perpendicularly to the connector. Push the plug into the connector
while turning it clockwise and counterclockwise several times.
4. Install the removed parts by reversing the steps of removal.
HXCU-TX70
4-12
To Next Page
Loading...
Need help?
General
