-
Operating
an
iPod
directly
-
Passenger
control
You
can operate an iPod connected
to
the dock
connector directly.
1 During playback, press and hold
(MODE).
"MODE IPOD" appears and you will be able
to operate the iPod directly.
To
change the display items
Press
(DSPL).
The display items change as follows:
Track name
~
Artist name
~
Album name
~
MODE IPOD
~
Clock
To
exit the passenger control
Press and hold
(MODE).
Then "MODE AUDIO" will appear and the play
mode will change
to
"RESUMING."
Notes
• The volume can be adjusted only by the unit.
•
If
this mode is canceled, the repeat setting will be
turned off.
Bluetooth
(Handsfree
calling
and
Music
streaming)
Bluetooth
operations
To
use the Bluetooth function, the following
procedure
is
necessary.
o Pairing
When connecting Bluetooth devices for the
first time, mutual registration is required. This
is
called "pairing." This registration (pairing)
is required only for the first time, as this unit
and the other devices will recognize each
other automatically from the next time.
You
can pair up
to
8 devices. (Depending on the
device, you may need to input a passcode for
each connection.)
e Connection
To
use the device after pairing is made, start
the connection. Sometimes pairing allows
to
connect automatically.
e Handsfree calling/Music streaming
You
can talk handsfree and listen
to
music
when the connection
is
made.
Support site
http://esupport.sony.com
http://www.xplodsony.com/
Pairing
First, register ("pair") a Bluetooth device
(cellular phone, etc.) and this unit with each
other.
You
can pair up
to
8 devices. Once pairing
is established, there
is
no need for pairing again.
1 Place the Bluetooth device within 1 m
(3 tt) of this unit.
2 Press and hold CID until
"0"
flashes
(about 5 seconds).
The unit enters pairing standby mode.
16
(
To Next Page
Loading...
Need help?
General
Weight and Dimensions
