Canceling
the
DEMO
mode
You can cancel the demonstration display which
appears during turning off.
1 Press and
hold
the
select
button.
The setup display appears.
2 Press
the
select
button
repeatedly
until
"DEMO"
appears.
3 Rotate
the
control
dial
to
select
"DEMO-OFF."
4 Press and
hold
the
select
button.
The setup is complete and the display returns
to normal play/reception mode.
Preparing
the
card
remote
commander
Remove the insulation film.
Tip
For
how
to
replace the battery, see page 25.
Setting
the
clock
The clock uses a l2-hour digital indication.
1 Press and
hold
the
select
button.
The setup display appears.
2 Press
the
select
button
repeatedly
until
"CLOCK-ADJ"
appears.
3 Press
(SEEK)
+.
The hour indication flashes.
4 Rotate
the
control
dial
to
set
the
hour
and minute.
To
move the digital indication, press
(SEEK)
+/-.
5
After
setting
the
minute,
press
the
select
button.
The setup is complete and the clock starts.
To
display the clock, press
(DSPL).
Press
(
DSPL)
again to return to the previous display.
Detaching
the
front
panel
You
can detach the front panel
of
this unit to
prevent theft.
Caution alarm
If
you tum the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
1 Press
(OFF).
The unit is turned off.
2 Press
~,
then pUll
it
off
towards
you.
Notes
• Do
not
drop
or
put
excessive pressure
on
the front
panel
and
display window.
• Do
not
subject the front panel
to
heatlhigh
temperature
or
moisture. Avoid leaving it in a parked _
car
or
on a dashboard/rear
tray.
• Do
not
detach the front panelduring playback
of
the
USB device, otherwise USB data
may
be damaged.
Attaching
the
front
panel
Engage part @
of
the front panel with part ®
of
the unit, as illustrated, and push the left side into
position until it clicks.
Note
Do not
put
anything on the inner surface
of
the front
panel.
7
To Next Page
Loading...
Need help?
General
Weight and Dimensions
