Deleting
registration
of
all
paired
devices
Operating an
audio
device
with
this
unit
You can perform the following operations on this
unit
if
the audio device supports AVRCP (Audio
Video Remote Control Profile)
of
Bluetooth
technology. (The operation differs depending on
the audio device.)
* Depending on the device, it may be necessary to
press twice.
Operations other than the above should be
performed on the audio device.
Notes
• During audio device playback, information such as
track number/time, playback status, etc.,
of
a
connected audio device is not displayed on this unit.
• Even
if
the source is changed on this unit, playback
of
the audio device does not stop.
Tip
You
can connect a cellularphone that supports A2DP
(Advanced Audio Distribution Profile)
as
an
audio
device
and
listen
to
music.
1 Press
(OFF).
This unit is turned off.
2
If"
0 "
lights,
press
and
hold
@I)
until
"0"
turns
off.
3 Press
and
hold
the
select
button.
4 Press
the
select
button
repeatedly
until
"BT
INIT" appears.
5 Press
(SEEK)
+.
Initializing starts.
It takes 3 seconds to cancel all registration.
Do
not
tum
off
the power while
"INITIAL"
is
flashing.
-
® (PAUSE)* on this unit.
® (PAUSE)* on this unit.
SEEK
-/+
(~/~)
[once for
each track]
Press
Play
Pause
Skip tracks
To
Listening
to
music
from
an
audio
device
You can listen to music
of
an audio device on this
unit
if
the audio device supports
A2DP
(Advanced Audio Distribution Profile)
of
Bluetooth technology.
1 Turn
down
the
volume
on
this
unit.
2 Press
(SOURCE)
repeatedly
until
"BT
AUDIO" appears.
3 Operate
the
audio
device
to
start
playback.
4
Adjust
the
volume
on
this
unit.
Adjusting the volume level
The
volume level is adjustable for any difference
between the unit and the Bluetooth audio device.
1 Start playback
of
the Bluetooth audio device at
a moderate volume.
2
Set
your usual listening volume
on
the unit.
3 Press the select button repeatedly until "BTA"
appears, and rotate the volume control dial to
adjust the input level
(-8
dB to +
18
dB).
Music
streaming
Notes
• Check that unit
and
cellular phone are connected
beforehand.
• Store
a voice tag on
your
cellular phone beforehand.
• If you activate voice dialing with a cellularphone
connected to this unit, this function
may
not
always
work
in
some cases.
• Noises such
as the engine running may interfere
with sound recognition.
In
order
to
improve
recognition, operate underconditions where noise
is
minimized.
• Voice dialing may
not
work in some situations,
depending on the effectiveness
of
the cellular
phone's recognition function. For details, see the
support site (page 27).
Tips
• Speak in the same way as you did when you stored
the voice tag.
• Store
a voice tag while seated
in
the car, via this unit
with "BT PHONE" source selected.
19
To Next Page
Loading...
Need help?
General
Weight and Dimensions
