[108] Adjusting Settings Speaker Setup
Setting the crossover frequency of the speakers
(Crossover Frequency)
You can set the bass crossover frequency of speakers for which the speaker size has been set
to [Small] in the [Speaker Setup] menu. A measured speaker crossover frequency is set for
each speaker after the Auto Calibration is performed.
Note
The surround back speakers will be set to the same setting as that of the surround speakers.
[109] Adjusting Settings Speaker Setup
Adjusting the equalizer (Equalizer)
You can use the following parameters to adjust the tonal quality (bass/treble level) of the front,
center, surround/surround back, height1 and height2 speakers.
Level (dB)
Frequency (Hz)
Bass
Treble
Note
This function does not work in the following cases:
[Direct] is being used and an analog input is selected.
[Pure Direct] is set to [On].
Frequencies for [Bass] and [Treble] are fixed.
Depending on the audio format, the receiver may play signals at a lower sampling frequency than the
original sampling frequency of the input signals.
Hint
You can also select [Equalizer] in [Sound Effects] from the home menu.
[110] Adjusting Settings Speaker Setup
Lifting up the sound of the center speaker (Center
Speaker Lift Up)
Select [Setup] - [Speaker Setup] from the home menu.
1
Select [Crossover Frequency].
2
Select the speaker for which you want to adjust the crossover frequency on the
screen.
3
Set the crossover frequency of the selected speaker.
4
Select [Setup] - [Speaker Setup] from the home menu.
1
Select [Equalizer].
2
Select [Front Speaker], [Center Speaker], [Surround], [Height1 Speaker] or [Height2
Speaker].
3
Select [Bass] or [Treble].
4
Adjust the gain.
5
To Next Page
Loading...
Need help?
General
