95
Auto transition
The transition from the current video to the new video is
executed automatically at a constant rate, using the
transition effect selected as the transition type.
You can set the transition rate in advance (see page 91).
Transition control block
To execute a transition, use the following procedure in the
transition control block.
To switch video instantaneously
Press the [CUT] button.
To switch video gradually
Press the [AUTO TRNS] button.
This executes the transition at the preset transition rate.
During the execution of the transition, the [AUTO
TRANS] button is lit amber.
To complete a partially executed transition
instantaneously
Press the [CUT] button.
The [AUTO TRANS] button turns off.
The [TAKE] button is used, instead of the [AUTO
TRANS] button on the transition control block (simple
type). Also, cut operations are not supported.
Executing a Transition with the
Fader Lever (Manual Transition)
Using the fader lever, you can manually control the
progress of the transition effect specified by the transition
type from the current video to the new video. Moving the
fader lever from one end of its travel to the other completes
the transition.
To execute a manual transition with the transition control
block fader lever, use the following procedure.
To execute the transition completely
Move the lever over the full range of its travel.
To pause a partly executed transition
Stop moving the fader lever.
To resume a paused transition
Resume moving the fader lever.
Auto/Manual Transition Combination
Using the [AUTO TRANS] button, the [CUT] button, and
the fader lever, use the following procedures.
Moving the fader lever during an auto
transition
During an auto transition started by pressing the [AUTO
TRANS] button, operating the fader lever immediately
enables the fader lever, and the [AUTO TRANS] button
turns off. Thereafter, the fader lever controls the execution
of the transition.
Executing an auto transition after stopping
the fader lever mid execution
Press the [CUT] button to instantaneously complete the
transition.
Press the [AUTO TRANS] button to complete the
execution of the rest of the transition at the preset transition
rate. For example, if the transition rate is set to 100 frames,
and the fader lever has moved through 1/4 of the transition,
then the remaining 3/4 of the transition is executed in 100
frames.
Non-Sync State
If the fader lever is in an intermediate position when a
transition is completed as an auto transition, then the lever
position no longer agrees with the transition state. This is
termed non-sync state.
In non-sync state, the position from which a normal sync-
state fader lever transition can be resumed is indicated by
which of the two transition indicator LEDs (top, bottom, or
both ends) are lit or flashing.
• Moving the fader lever toward the position of the lit/
flashing LEDs does not execute a transition, but when
the fader lever reaches the end position the non-sync
Note
AUTO TRANS button
CUT button
Fader lever
To Next Page
Loading...
Need help?
General
