6-3
Routine Maintenance Operator Manual 122994-513
4.0 CHAMBER COMPONENTS (Cont’d)
4.5 Verify proper water level and temperature.* 3 X/year
4.6 Verify piping system for leaks. Repair if necessary.* 6 X/year
4.7 Verify condition of sliding guides. Replace if necessary.* 3 X/year
5.0 SUPPLY-LINE STRAINERS
Inspect strainers for debris. Clean as necessary (see S
ECTION 6.5.2). 6 X/year
6.0 CHEMICALS AND INJECTION PUMPS
6.1 Verify suction tube is not clogged, cracked or distorted. If damaged, call STERIS.* 6 X/year
6.2 Inspect and lubricate squeeze tubes. Replace if necessary (see S
ECTION 6.7). 6 X/year
6.3 Verify amount of chemical product injected. Adjust if necessary. 3 X/year
6.4 Lubricate pump roller (see S
ECTION 6.7). 6 X/year
7.0 COMPRESSOR
Verify intake filter and mufflers. Change if necessary.* 2 X/year
8.0 PROTECTIVE GROUND TERMINAL*
Verify protective conductor at equipment terminal and verify if connection is well
secured inside terminal with proper torque equipment. Torque requirement for
supply conductor terminals for steam-heated units (L1-L2-L3- N) is: 7.1 - 8.9 lb/in
(0.8 -1.0 N•m) and for electric-heated units (L1-L2-L3- N) is: 7.1 - 8.9 lb/in (0.8 -
1.0 N•m); for steam- and electric-heated units, protective conductor terminal is:
20 lb/in (2.2 N•m).*
1 X/year
9.0 FINAL TEST
9.1
Clean dirt and lint from components. Verify all wiring, terminals and socket connec-
tions for damage or fraying.
6 X/year
9.2 Verify glassware washer has proper labels (caution, warning, etc.). 6 X/year
9.3 Install any panel or cover removed during inspection. 6 X/year
9.4 Test glassware washer operation. 6 X/year
*Contact STERIS for this service. Preventive Maintenance is not covered under warranty.
Table 6-1. Preventive Maintenance Guide (Cont’d)
Recommended frequency of inspection is indicated in the right column. Usage and
utility conditions may require more or less frequent inspections.
Suggested
Frequency
To Next Page
Loading...
Need help?
General
