13
User’s manual
EN
SAFETY DEVICES
1. Bumpers
The bumper sensor is enabled if the robot strikes a solid object higher than 10 cm (3.94 in.).
This sensor will stop the movement in that direction and move backwards to avoid the obstacle.
2. Inclinometer
If the robot works on a slope which is steeper than the maximum limit, or tips over, this safety
device will stop the cutting blade.
3. Emergency stop switch
Located on the control panel, red in colour. Pressing this button at any time during operation
will immediately stop the movement of the mower and the rotation of the blade will stop within
2 seconds.
4. Over-current protection
The motors (blade and wheels) are monitored continuously during operation for any situation
that may cause them to overheat. If this occurs in the wheel motor, the robot will attempt to
move in the opposite direction. If the over-current persists, the robot will stop and signal an
error. If the cutting motor overheats, then there are two types of intervention. If the parameters
fall within the rst range, the robot will perform the manoeuvres to unblock the cutting blade.
If the over-current is below the protection range, the robot will stop and signal a motor error.
5. No signal of the sensor
If there is no signal on the perimeter cable, the robot will automatically stop.
6. Lifting sensor.
In the event that the robot is lifted from the ground by the central handle, the cutting blade will
stop rotating.
SAFETY FOR MAN AND THE ENVIRONMENT DURING DISPOSAL
• Do not disregard any polluting material into the environment. Dispose of the robot according to the
applicable laws.
• In reference to the WEEE Directive (Waste of Electrical and Electronic Equipment), during the phasing
out of the machine, the user must separate the electrical and electronic components and dispose of
them in special authorised waste collection centres, or take them back to the retailer when purchasing
a new one.
• All the parts, which must be collected separately or disposed of in a speci c manner, are marked with
a special label.
• Unauthorised disposal of Waste of Electric and Electronic Equipment (WEEE) is punishable with
sanctions regulated by the laws in force in the country where the infraction took place.
• For example, to implement the European directives (2002/95/CE, 2002/96/CE, 2003/108/CE) in Italy,
a legislative decree was issued (No. 151 of 25 July 2005) which provides for an administrative ne of
€ 2000÷5000.
Electric and Electronic Equipment may contain hazardous substances having
potentially harmful effects on the environment and on the health of people. It is
recommended to correctly dispose of this waste.
Danger - Attention
To Next Page
Loading...
Need help?
General
