29
User’s manual
EN
6. Lower the hood and fasten the knobs (A).
knobs (A)
ADJUSTMENT OF THE RAIN SENSOR
7. Stop the robot in safe conditions (see
“Robot Safety Stop”).
8. Adjust the distance between the pins (A-B)
by turning the eccentric pin (A).
pin (B) eccentric pin (A)
The sensitivity of the sensor increases as
the distance between the pins decreases.
Do not bring the pins too close to each
other.
If the sensor detects rain, the robot operates
according to what is set in the program (see
“Programming Mode”).
To Next Page
Loading...
Need help?
General
