0478 131 8354 D - EN
50
5. Start signal:
For switching on and off the acoustic
signal that sounds when the mowing
blade is activated.
6. Alarm signal:
For switching on and off the acoustic
signal that sounds when the robotic
mower hits an obstacle.
7. Menu signal:
For switching on and off the acoustic
click that sounds when a menu is
opened and a selection is confirmed with
OK.
8. Keylock:
When the keylock is switched on,
the buttons on the control panel
can only be operated if the Back
button is pressed and held and the
control pad is then pressed forwards.
The keylock is activated 2 minutes after
the last button has been pressed.
9. Link iMOW® and dock:
Following initial operation, the
robotic mower can only be operated
in conjunction with the docking station
supplied.
Following a replacement of the docking
station or of electronic components in the
robotic mower or for initial operation of the
robotic mower on an additional mowing
area using a different docking station, the
robotic mower and docking station must be
linked.
● Install the docking station and connect
the perimeter wire. (Ö 9.8), (Ö 9.11)
Lift the robotic mower slightly by the
carrying handle (1) and relieve the weight
on the drive wheels. Push the machine,
resting on its front wheels, into the docking
station.
● After pressing the OK button,
enter the PIN code. The robotic
mower will then search for the
wire signal and save it automatically.
This process takes several minutes.
(Ö 9.10)
11.16 Service
1. Blade change:
Installation of a new mowing blade is
confirmed with OK. The counter is reset.
2. Find wire break:
If the red LED on the docking station
flashes rapidly, there is a break in the
perimeter wire. (Ö 13.1)
● Finding a wire break (Ö 16.7)
3. Hibernation:
OK places the robotic mower in
hibernation. The settings are kept, the time
and date are reset.
● Charge the battery fully before
hibernation.
● When resuming operation, wake up the
machine by pressing any button.
4. Reset settings:
The robotic mower is reset to the factory
defaults with OK, the installation assistant
is restarted. (Ö 9.6)
● Enter the PIN code after pressing
the OK button.
11.17 Information
1. Messages:
List of all active errors, faults and
recommendations; shown together
with the times of occurrence.
During trouble-free operation, the text "No
Recommendation:
Write down the new PIN code.
If the PIN code is entered
incorrectly 5 times, a 4-digit master
code is required, otherwise
automatic operation is switched off.
To create the master code, contact
your STIHL specialist dealer or
contact iMOW® Support directly at
support@imow.stihl.com.
Please provide the 9-digit serial
number and the 4-digit date, which
are shown on the iMOW® display.
No PIN code is required in the
safety level "None".
No PIN code is required in the
safety level "None".
To Next Page
Loading...
Need help?
General
