8-58 CHASSIS
CALIPER INSTALLATION
Install the caliper in the reverse order of removal. Pay attention
to the following points:
• Tighten the brake caliper mounting bolts 1 to the specified
torque.
Front brake caliper mounting bolt:
26 N·m (2.6 kgf-m, 19.0 lbf-ft)
• Install the brake hose with union bolt and new seal washers.
• After setting the brake hose union to the stopper, tighten the
union bolt 2 to the specified torque.
Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lbf-ft)
• Bleed air from the brake system after installing the caliper.
(2-21 to -22)
BRAKE DISC INSPECTION
• Visually check the brake disc for damage or cracks.
• Measure the thickness with a micrometer.
• Replace the disc if the thickness is less than the service limit
or if damage is found.
Front disc thickness: Service Limit: 4.5 mm (0.18 in)
09900-20205: Micrometer (0 – 25 mm)
• Dismount the brake caliper.
• Measure the runout with the dial gauge.
• Replace the disc if the runout exceeds the service limit.
Front disc runout: Service Limit: 0.30 mm (0.012 in)
09900-20607: Dial gauge
09900-20701: Dial gauge chuck
Brake disc removal .................................. (8-9)
Brake disc installation............................. (8-13)
Brake fluid, if it leaks, will interfere with safe running
and discolor painted surfaces. Check the brake hose
and hose joints for cracks and fluid leakage.
To Next Page
Loading...
Need help?
General
