ENGINE 3-41
 Apply THREAD LOCK SUPER to the bolts, and then tighten
them to the specified torque with a offset wrench.
" Starter clutch bolt: 26 N•m (2.6 kgf-m, 19.0 lb-ft)
* 99000-32030: THREAD LOCK SUPER îš“ 1303îš”
& 09930-44520: Rotor holder
 Install the starter driven gear to the starter clutch.
 Check that the starter driven gear turns only in counter clock-
wise.
 If there is anything unusual, replace the one way clutch.
 Check the starter driven gear bearing. If there is anything
unusual, replace the bearing.
 Remove the bearing with the special tool.
& 09913-70210: Bearing installer set
 Install the bearing with the special tool.
& 09913-70210: Bearing installer set
PartShark.com
877-999-5686
To Next Page
Loading...
Need help?
General
