EasyManuals Logo
Home>Suzuki>Motorcycle>RGV250 1989

Suzuki RGV250 1989 User Manual

Suzuki RGV250 1989
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
REF.
NO.
27.
28.
29.
30.
31.
32.
33.
34.
PART NUMBER
11341-12C50
11370-12C50
11482-12C00
11342-12C50
11971-12C50
07120-06252
11972-12C50
24121-12C60
DISCRIPTION
COVER,CLUTCH INNER
COVER, CLUTCH OUTER
GASKET, CLUTCH COVER
PLUG,
KICK SHAFT
PLUG,
OILFILLER
BOLT
PLUG,
OIL DRAIN
COUNTER SHAFT FOR
DRY TYPE
Q'TY/UNIT
1
1
1
1
1
4
1
1
REMARKS
6x25
NT:
16 (Not shown)
6. OIL CATCH TANK
1.
Remove the under cowl.
2.
Remove the front seat.
3. Remove the fuel tank.
4.
Remove the air cleaner.
5. Install the oil catch tank on the chassis as shown in Fig. 2.
Remove the front bolt securing the carburetor idle adjuster screw bracket. Refit this bolt to secure
the rear side of oil catch tank bracket together with the idle adjuster screw bracket.
Pass the clamp (selt-locking tie strap) through the front bracket of oil catch tank and fasten the
clamp on the frame down tube. Use care at this time not to pinch the wiring harness between the
bracket and frame.
6. Remove the crankcase breather hose from the guide which is fastened together with the 1st muffler
mounting on the lower part of chassis right side. Route this breather hose to the oil catch tank as
shown in Fig. 1.
7. Insert one end of the outlet pipe (overall length 2 m) into the oil catch tank and route the pipe to the
rear of the machine. If the pipe is found too
long,
cut it to the proper length. When clamping the pipe
on the frame together with the wiring harness, use care not to pinch it.
8. Install the air cleaner.
9. Install the fuel tank.
10.
Attach the self-adhesive clamp on the frame (tank rail) as shown in Fig. 1 and Fig. 2.
11.
Replace the fuel tank breather hose with a longer one (length 790 mm).
Insert one end of the fuel tank breather hose into the oil catch tank and secure the pipe on the
frame by using the clamp previously installed. If the pipe is found too
long,
cut it to the proper
length.
12.
Install the seat and under cowl.
13.
Finally, check that the steering does not interfere with the fuel tank breather hose when fully turned
right and left.
-11 -

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzuki RGV250 1989 and is the answer not in the manual?

Suzuki RGV250 1989 Specifications

General IconGeneral
BrandSuzuki
ModelRGV250 1989
CategoryMotorcycle
LanguageEnglish

Related product manuals