3
LOCATION OF PARTS
Check all the components which have been removed from the base of the crate.
Parts listed above are installed respectively into the positions as follows.
Item Part Name Q’ty Remarks
A
Handlebars assembly 1
Clamp 2
Allen bolt 4 8 × 25 mm
Burring washer 4 OD:13.0 ID:8.5
Plastic cap 4
OD:11.0
For handlebar
clamp bolt
Clutch lever cover 1
Screw 1
5 × 45 mm
For left switch
Screw 1
5 × 25 mm
For left switch
Screw 1
5 × 30 mm
For throttle
assembly
Strap 2 L:140
B
Holder 1
For front brake
master cylinder
Flange bolt 2 6 × 22 mm
Item Part Name Q’ty Remarks
C
Handlebar balancer
weight
1 Right
Screw 1 6 × 65 mm
Rubber cushion 1 L:15.0
Spacer 1 L:15.0
Rubber cushion 1 L:15.0
Spacer nut 1 6 mm
D Rear view mirror 2 Right and Left
E Washer 2 OD:20.0 ID:6.5
F
Battery electrolyte
container
1
GOwner’s manual set 1
H Warning label 7
For
E-19 CC selection
I Warning label 4
For
E-19 CD selection
OD : Outside diameter (mm)
ID : Inside diameter (mm)
L : Length (mm)
T : Thickness (mm)
T
L
OD ID
NOTE:
The parts shown as Item E, H and I in the above table are supplied for limited markets.
Use washers of Item E for mounting the license plate.
A
D
D
B
C
To Next Page
Loading...
Need help?
General
