5
Before assembling the motorcycle, thoroughly
understand the “Safety Check Out” described on
page 32.
After completion of assembly, carefully check the
motorcycle referring to the “Safety Check Out”,
then deliver the motorcycle to the customer.
ASSEMBLY
REMOVING THE BRACKET
Remove the bolt to take off the front brake master cyl-
inder from the bracket.
A: Front brake master cylinder
B: Bolt
C: Bracket
Remove the bolts to take off the bracket from the han-
dlebar holder.
A: Bracket
B: Bolt
Keep the position of front brake master cylinder
with its cap facing upwards until it is installed.
NOTE:
The bolt is no longer needed and this may be
discarded.
Be careful not to damage the fuel tank.
NOTE:
The bracket and bolts are no longer needed
and these may be discarded.
To Next Page
Loading...
Need help?
General
