■ The following is the description for each button.
Color
＋＋
(Number key
““
1
””
) : Shows the increase of stitches until the next color.
Color
－－
(Number key
““
2
””
) : Shows the decrease of stitches until the previous color.
＋＋
100 (Number key
““
3
””
) : Shows the design after adding 100 stitches each time .
－－
100 (Number key
““
4
””
) : Shows the design after subtracting 100 stitches each time.
＋＋
1000 (Number key
““
5
””
) : Shows the design after adding 1000 stitches each time.
－－
1000 (Number key
““
6
””
) : Shows the design after subtracting 1000 stitches.
Fast/Slow (Number key
““
7
””
) : Chooses to display the design on the screen fast or slow. “Fast”means low
speed. To set it as the fast speed, press the button again, and then “Slow”
appears. This is the setting for high speed. At this stage, when the button is
pressed again, the setting returns to the original setting of low speed.
: Initializes the screen where virtual embroidery is being conducted.
: After setting the speed, press this button. Then, the design drawing on the screen begins.
: When it is pressed after the start button is pressed, the drawing is paused.
: Exits from Route Check.
To Next Page
Loading...
Need help?
General
