5.7.3 Design Filtering
If the distance from one stitch to the other stitch is too short (0.1∼0.3mm), the thread might break very often
during embroidery work. This function is to put together short stitches which are under the set value for
optimization and enhance the entire number of stitches above the set value, so that it can prevent thread break.
The below screen <Fig. 5.7.3-1> appears when Optimize is pressed.
[Fig. 5.7.3-1] [Fig. 5.7.3-2]
[Exercise 5.7.3-1] If there are stitches of 0.4mm or below in the called design, set the
machine to embroider the stitches above the length of 0.4mm.
Press on the main function menu.
Select Optimize on the edit menu and press .
Check whether there are stitches of 0.4mm or below.
If so, press for stitch optimization.
Check the room number for saving and press .
<Fig. 5.7.3-2> is the screen for confirming optimization after calling the optimized design.
To Next Page
Loading...
Need help?
General
