11--22
The right side is protected by the connector cover against foreign materials including dust. Press the cover once to open.
① Keyboard Port
② VGA Port
③ Serial Port
This is used for serial communications.
④ LAN Port for Networking
⑤ USB Port
It is used to save and call designs in and out of the embroidery machine by using a USB memory.
⑥ USB Port (slave)
This is a reserve port for the USB-based communication with PC.
⑩ Frame Move Keys
They are used to move the frame in the four directions including Up, Down, Left, and Right. They are also used to
move around the menu on the screen.
⑪ Frame Speed Key
It is used to adjust the speed in three steps including high, medium, and low when moving the frame.
① Cable Connection for FDD
It is used to make connection to the external FDD using a cable.
② Cable Connection for Power Supply and Signal Transmission
[Fig. 1.1-2] [Fig. 1.1-3]
▶
Right
①
②
③
④
⑤
⑥
[Fig. 1.1-4]
▶
Rear
①
②
To Next Page
Loading...
Need help?
General
