Section
7-2465
Operators
OPTIONS AND ACCESSORIES
INTRODUCTION
This section contains
a
general description of instrument
options available
at
the time of publication of this manual.
Also included is
a
complete list (with Tektronix part num-
bers) of standard accessories included with each instrument
and
a
partial
list
of optional accessories. Additional
information about instrument options, option availability,
and other accessories can be obtained either by consulting
the current Tektronix Product Catalog or by contacting
your local Tektronix Field Office or representative.
OPTION
11
Option 11 provides two probe-power connectors on the
rear panel of the instrument. Voltages supplied at these
connectors meet the power requirements of standard
Tektronix active oscilloscope probes.
OPTION
I
R
When the 2465 Oscilloscope
is
ordered with Option 1
R,
it
is
shipped in
a
configuration that permits easy installation
into
a
19-inch-wide electronic-equipment rack.
An optional rear-support kit also
is
available for use
when rackmounting the 2465. Using this optional rear-
support kit enables the rackmounted instrument to meet
all electrical and environmental specifications of the
standard 2465 Oscilloscope.
Connector-mounting holes are provided in the front
panel of the rackmounted instrument. These enable con-
venient accessing of the four BNC connectors
(CH
2
SIGNAL OUT, A GATE OUT, B GATE OUT, and EXT
Z
AXIS
IN)
and the two PROBE POWER connectors located
on the rear panel. Additional cabling and connectors
required to implement any front-panel access to the rear-
panel connectors are supplied by the user; however, these
items can be separately ordered from Tektronix.
Complete rackmounting instructions are provided in
a
separate document shipped with the 2465 Option 1R.
These instructions also contain appropriate procedures to
convert
a
standard instrument into the Option 1
R
con-
figuration by using the rackmounting conversion kit.
POWER CORD OPTIONS
Instruments are shipped with the detachable power-cord
configuration ordered by the customer. Descriptive infor-
mation about the international power-cord options
is
provided in Section 2, "Preparation for Use." The following
list identifies the Tektronix part numbers for the available
power cords and associated fuses.
Option A1 (Universal Euro)
Power cord (2.5 m)
Fuse (1.6 A, 250 V,
5 x 20 mm, Quick-acting)
Option A2
(UK)
Power cord (2.5 m)
Fuse (1.6 A, 250 V,
5
x
20 mm, Quick-acting)
Option A3 (Australian)
Power cord (2.5 m)
Fuse (1.6 A, 250 V,
5 x 20 mm, Qu ick-acting)
Option A4 (North American)
Power cord (2.5 m) 161-0104-08
Fuse (2 A, 250 V, AGC/3AG,
Fast-blow) 1 59-002 1 -00
Option A5 (Switzerland)
Power cord (2.5 m)
Fuse (I .6 A,
250
V,
5 x 20 mm, Quick-acting)
To Next Page
Loading...
Need help?
General
