Save and Recall Informat ion
Save and Recall Information
The oscilloscope provides permanent storage for setups, waveforms, and screen images. Use the internal storage of the
oscilloscope to save setup files and refe rence waveform data.
Use external USB flash drives, to save setups, waveforms, and screen images. Use the external storage to carry data to remote
computers for further analysis and for a rchiving.
External File Structure. If you are saving information to external storage, select the appropriate menu (such as the To File
side-bezel menu to save setups and waveforms) and turn multipurpose knob a to scroll through the external file structure.
E: is the USB fl ash drive plugged into the USB port on the front of the oscilloscope
F: is the USB flash drive plugged into the USB port on the rear of the oscilloscope
Use multipurpose knob a to scroll through the list of files. Use the Select front panel button to open and close folders.
Naming Your File. The oscilloscope gives all files it create s a default name in the following format:
tekXXXXX.set for setup files where XXXXX is an integer fro m 00000 to 99999
tekXXXXX.png, tekXXXXX.bmp, or tekXXXXX. tif for image files
tekXXXXYYY.csv for spreadsheet files or tekXXXXYYY.isf for internal format files
For waveforms, the XXXX is an integer from 0000 to 9999. The YYY is the channel of the w aveform, and can be one of the following:
CH1, CH2, CH3, or CH4 for the analog channels
MTH for a math waveform
DPO3000 Series Oscilloscopes User Manua l 199
To Next Page
Loading...
Need help?
General
