Tektronix DPO3000 Series User Manual

Installation
4. Power on the oscilloscope. The instrument
automatically recognizes the replacement
firmware and installs it.
If the instrument does not install the firmw are,
rerun the procedure. If the problem continues,
try a different model of USB flash drive. Finally,
if needed, contact qualified service personnel.
NOTE. Do not power off the oscilloscope or
remove the U SB flash drive until the oscilloscope
finishes installing the firmw ar e.
36 DPO3000 Series Oscilloscopes User Ma nual

Tektronix DPO3000 Series Specifications

General

Brand	Tektronix
Model	DPO3000 Series
Category	Test Equipment
Language	English