Tektronix MDO4000B Series User Manual

Commands Listed in Alphabetical Order
AFG:ARB:EMEM:
GEN SQU 1000
will generate a 1000 point square wave.
AFG:ARBitrary:EMEM:NUMPoints? (Query Only)
Returns the n
umber of points in the AFB arbitrary waveform edit memory.
This value will be used with the AFG:ARBitrary:EMEM:GENerate
command in the event that the number of points is not specified. See the
AFG:ARBitrary:EMEM:GENerate command description for more information.
Conditions
MDO3000 series with option MDO3AFG installed and MDO4000C series with
option MDO4AFG installed only.
Group
ARB
Syntax
AFG:ARBitrary:EMEM:NUMPoints?
Examples
AFG:ARB:EMEM:NUMP? might return 100, indicating that there are 100 points in
the AFB arbitrary waveform edit memory being used to generate the function.
AFG:ARBitrary:EMEM:POINTS
Specifies which points to load into the AFG arbitrary waveform edit memory.
The point data to be loaded may be specified as an IEEE488.2 binary block
with 4-byte floating point data values, or as a comma-separated list of NR2
or NR3 data values. The data values must be in the range of -1.0 to 1.0. The
AFG.ARBitrary.EMEM.POINTS.BYTEORDer command is used when the data
is binary block format. The minimum number of points is 2 and maximum is
131072.
Upon successful transfer of the data points, the AFG:ARBitrary:EMEM:
NUMPoints? query will return the number of points loaded into arbitrary
waveform edit memory and the AFG:ARBitrary:EMEM:FUNCtion? query will
return
USER. Note that the output, if turned on, will not change unless or until the
AFG function is set to
ARBitrary using the AFG:FUNCtion command.
Point values may be coerced to the nearest valid step size.
The query form returns the points stored in the AFG arbitrary waveform edit
memory in the format specified by the AFG:ARBitrary:EMEM:POINTS:ENCdg
command and, for binary encoding, the byte order specified by the
AFG.ARBitrary.EMEM.POINTS.BYTEORDer command.
Refer to the AFG:ARBitrary:EMEM:POINTS:ENCdg command description
for more information.
2-128 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual

Tektronix MDO4000B Series Specifications

General

Brand	Tektronix
Model	MDO4000B Series
Category	Test Equipment
Language	English