Specifications
Table 37: Zero S
pan Analog Output (Opt. 66)
Characteristic Description
Output Voltage, typical 1.0 V @ 0 dBm input
0 dBm reference level, 10 dB/div vertical s cale, measured into a 50 load.
Full-sc ale v
oltage is relative to reference level.
Output Volt
age Slope, nominal
10 mV/dB
10 dB/div vertical scale, measured into a 50 load. Slope will vary with vertical
scale setting.
Maximum Output Voltage, nominal
1.25 V
Output Voltage Accuracy, typical ±5% of full-scale voltage
Output Range Log Fidelity, typical >60 dB @ 1 GHz C F
Output Log Accuracy, typical
± 0.75 dB within range
Output Bandwidth, nominal
Up to maximum RBW
RBW as defined by the active display.
Continuous Output, nominal Continuous output for spans up to the maximum real-time acquisition bandwidth
of the i
nstrument.
Output is disabled for swept spans.
Output Impedance, nominal ON: 50
OFF: 5 k
Output Reverse Power Protection, typical
±20 V
Connector, nominal BNC female
Output Delay Readout Accuracy, typical ±(2 s + 10%)
The
Delay Readout Accuracy is the delay from the RF Input to the Z ero-Span Output.
Electrical Functional Specifications
Table 38: Measurement function
Characteristic Description
Power and Frequency Domain Measurement
Functions, nominal
Channel Power
A
djacent Channel Power
Multi-carrier Adjacent Channel Power/Leakage Ratio
dBm/Hz Marker
dBc/Hz Marker
Time Domain and Statistical M easurement
Functions, nominal
RF I/Q vs. Time
Power vs. Time
Frequency vs. Time
Phase vs. Time
CCDF
Peak-to-Average Ratio
Analog Modulation Analysis, nominal
%Amplitude Modulation (+, –, rms, modulation depth)
Frequency Modulation (±peak, +peak to –peak, rms, peak-peak/2, frequency error)
Phase Modulation (±peak, rms, +peak to –peak)
RSA5100B Series Technical Reference 43
To Next Page
Loading...
Need help?
General
