EasyManuals Logo
Home>Tektronix>Test Equipment>TDS 410A

Tektronix TDS 410A Service Manual

Tektronix TDS 410A
300 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
TDS 520A, 524A, 540A, & 544A Service Manual
1Ć9
Nominal Traits
This subsection contains tables that list the electrical and mechanical 
 that describe the TDS 520A, 524A, 540A, & 544A Digitizing
Oscilloscopes.
Nominal traits are described using simple statements of fact such as Four, all
identical" for the trait Input Channels, Number of", rather than in terms of
limits that are performance requirements.
TableĂ1Ć2:ăNominal Traits Ċ Signal Acquisition System
Name
Description
Bandwidth Selections 20 MHz, 100 MHz, and FULL (500 MHz)
Digitizers, Number of TDS 540A and 544A: Four, all identical
TDS 520A and 524A: Two, both identical
Digitized Bits, Number of 8 bits
1
Input Channels, Number of TDS 540A and 544A: Four, all identical, called CH1 - CH4
TDS 520A and 524A: Two fullĆfeatured (CH1 and CH2), plus two limĆ
ited, auxiliary inputs (AUX1 and AUX2)
Input Coupling
2
DC, AC, or GND
Input Impedance Selections
1MW or 50 W
Ranges, Offset, TDS 540A, 544A, and
CH1 and CH2 on TDS 520A and 524A
Volts/Div Setting
1 mV/div - 99.5 mV/div
100 mV/div - 995 mV/div
1 V/div - 10 V/div
Offset Range
±1 V
±10 V
±100 V
Ranges, Offset, AUX1 and AUX2 on TDS
520A and 524A
Volts/Div Setting
100 mV/div
1 V/div
10 V/div
Offset Range
±0.5 V
±5.0 V
±50 V
Range, Position ±5 divisions
Range, Sensitivity TDS 540A and 544A: 1 mV/div to 10 V/div
3
TDS 520A and 524A: CH1 and CH2: 1 mV/div to 10 V/div
3
TDS 520A and 524A: AUX1 and AUX2: 100 mV/div, 1 V/div, 10 V/div
1 Displayed vertically with 25 digitization levels (DLs) per division and 10.24 divisions dynamic range with zoom off. A DL is the
smallest voltage level change that can be resolved by the 8Ćbit AĆD Converter, with the input scaled to the volts/division setting of
the channel used. Expressed as a voltage, a DL is equal to 1/25 of a division times the volts/division setting.
2 The input characteristics (Input Coupling, Input Impedance Selections, etc.) apply to both fullĆfeatured and auxiliary inputs except
where otherwise specified.

Table of Contents

Other manuals for Tektronix TDS 410A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix TDS 410A and is the answer not in the manual?

Tektronix TDS 410A Specifications

General IconGeneral
BrandTektronix
ModelTDS 410A
CategoryTest Equipment
LanguageEnglish

Related product manuals