Tenda I-WL-O3 User Manual

6
1.2 CCTV surveillance
To ensure the safety of employees and property, a video surveillance system needs to be installed
in a building site.
1.2.1 Solution
Tenda CPE can meet this demand.
O4 is used as an example to illustrate the installation procedures. Procedures for other CPEs are
similar.
1.2.2 Set up the CPEs
At least two CPEs are required for bridging.
Option 1: Automatic bridging (recommended)
 Automatic Bridging is only applicable when the CPEs are in factory settings.
 When performing peer-to-peer bridging, ensure that only two CPEs are powered on nearby.
Otherwise, the peer-to-peer bridging may fail.
 For peer-to-multiple peers bridging, perform peer-to-peer bridging first, and then power on the
rest CPEs within 30 minutes.
 A CPE can bridge to 15 CPEs at most.
Scenario 1: Peer-to-peer bridging
Step 1 Place the two CPEs next to each other, see the following figure.

Tenda I-WL-O3 Specifications

General

Brand	Tenda
Model	I-WL-O3
Category	Network Router
Language	English