57
4.9 P2MP mode
In P2MP mode, this device connects 2 or more (this device supports 4 at most) wired networks
with a wireless link, but cannot be connected to wireless clients.
The configuration procedure of P2MP mode is similar with Repeater mode. In the following
example, the CPE works in P2MP mode, and bridges to four CPEs work in Repeater mode.
Application scenario
The CPE is used to combine two local networks into one in wireless manner. The network topology
is shown as below:
Assume that the related parameters are shown as follows:
CPE1:
− IP Address: 192.168.2.1
− SSID: Tenda_1
− Channel: 165
− Security Mode: None
To Next Page
Loading...
Need help?
General
