Wireless N300 Home Router
50
Chapter 5 Bandwidth Control
5.1 Bandwidth Control
Use this section to manage bandwidth allocation to devices on your LAN. If
there are multiple PCs behind your router competing for limited bandwidth
resource, then you can use this feature to specify a reasonable amount of
bandwidth for each such PC, so that no one will be over stuffed or starved to
death.
1. Enable Bandwidth Control: Check or uncheck the box to
2. Enable or disable the bandwidth control feature.
3. IP Address: Specify the same IP address (say, 100, 100) or two
different IP addresses (say, 100, 110) in both boxes to specify a single
IP address or an IP range to which the current bandwidth control rule will
apply.
4. Upload/Download: Select to control bandwidth over data upload or
download.
5. Bandwidth Range: Specify an upload/download bandwidth range
limit on specified PC(s). The unit is KByte/s. 1M=128KByte/s. Note that
maximum upload/download bandwidth should not exceed your router's
WAN bandwidth limit. (Consult your ISP if you are not clear.).
6. Enable: Check to enable current rule. (When disabled, corresponding
entry will not take effect though existing in fact.)
7. Add to List: Click to add current rule to the rule list.
8. OK: Click to activate your settings.
For example:
To Next Page
Loading...
Need help?
General
