Wireless N300 Home Router
62
1. Filter Mode: Select Permit Only.
2. Access Policy: Select an access policy number, say, 1, from the
drop-down list.
3. Policy Name: Briefly describe the current rule, say, Permit only, (It
can only consist of numbers, letters, or underscore).
4. MAC Address: Enter 00:E4:A5:44:35:69.
5. Time: Select 0 for all fields to apply the rule 24hrs/day.
6. Day(s): Select Monday to Friday.
7. Enable: Check the Enable box.
8. OK: Click to save your settings.
7.3 Client Filter
This section allows you to set the times specific clients can or cannot access
the Internet via the devices’ assigned IP addresses and service port.
Forbid Only (or Deny/Forbid): Only PCs listed as Forbidden (or Denied)
will be forbidden from accessing specified services; others are not restricted;
Permit Only (or Permit/Allow): Only PCs listed as permitted (or allowed)
will be permitted to access specified services; others will be forbidden.
1. Filter Mode: Select Permit Only.
2. Access Policy: Select an access policy number, say, 1, from the
drop-down list.
3. Policy Name: Briefly describe the current rule, say, 80.
4. Start IP/End IP: Enter the same IP address, say, 110, or 2 different IP
addresses, say, 110 and 120 in both boxes to specify a single PC or a
range of PCs for the current rule to apply to.
To Next Page
Loading...
Need help?
General
