Wireless N300 Home Router
57
Enable UPnP: Check/uncheck to enable/disable the UPnP feature.
OK: Click to complete your settings.
6.5 Static Routing
When there are several routers in the network, you may want to set up static
routing. Static routing determines the path of the data in your network. You
can use this feature to allow users on different IP domains to access the
Internet via this device. It is not recommended to use this setting unless you
are familiar with static routing. In most cases, dynamic routing is
recommended, because this feature allows the router to detect the physical
changes of the network layout automatically. If you want to use static
routing, make sure the router’s DHCP function is disabled.
1. Destination Network IP Address: Specify a single IP address, say,
172.17.0.100, or an IP net segment, .say, 192.168.88.0.
2. Subnet Mask: Specify a Subnet Mask that corresponds to the specified
destination IP.
3. Gateway: Specify the IP address for next hop.
4. OK: Click to activate your settings.
Note:
1. Gateway must be on the same IP net segment as device's LAN/WAN IP
address.
2. Subnet Mask must be entered 255.255.255.255 if destination IP address
is a host.
3. Subnet Mask must be entered accordingly if destination IP address
represents an IP network segment. It must correspond to the specified
IP address. For example, for IP address of 10.0.0.0, you may enter a
To Next Page
Loading...
Need help?
General
