10. Error messages
27
If problems occur which are not described here, please contact Testo or your local distributor. You will
find contact details in the Warranty booklet or in Internet at
www.testo.com
.
Possible causes
Battery power too low
Battery empty
Measuring program was
cancelled by Reset
An attempt was made to
start the data logger via
GO
: data logger indicates
that
Start criterion PC
Start
is programmed.
An attempt was made to
start the data logger via
GO
: data logger indicates
that
Start criterion
Date/Time Start
is
programmed.
The
GO
button was
pressed for more than 3
seconds in the
END
mode
Remedy / Comments
Read out data and change battery
(See 9. Changing battery, P. 26)
Communication with PC is possible. Communi-
cation with testo 575 fast printer/ testo 580
data collector is not possible.
Change battery (See 9. Changing
battery, P. 26)
No communication with PC / testo 575 fast
printer/ testo 580 data collector possible.
Reactivate data logger via testo ComSoft
software
Start the data logger via PC
or change the
Start criterion
to
Key start
.
Change
Start criterion
to
Key start
.
No function is allocated.
Error message
OFF
and
END
are lit,
flashes
OFF
is lit
OFF
,
END
and
are lit
PC
is lit
date
is lit
Red and green LEDs
flash alternately five
times
To Next Page
Loading...
Need help?
General
