33
11. Technical data
11.6 Battery life
Typical approximate values for the expected battery life are
included in the programming windows of the software. These
values are calculated on the basis of the following factors:
- Measuring rate
- Number of probes connected
- Status led (green LED) activated/deactivated
The calculated data is only an approximation since the battery life
depends on many additional factors.
The following factors have a negative influence on the battery life:
- Alarm LED flashing for longer periods of time
- Frequent reading out (several times a day)
- Strong fluctuations in operating temperature
The following factors have a positive influence on the battery life:
- Deactivated Status led (green LED) particularly in the case
of extended measuring rates
The battery capacity displayed is based on calculated values.
The data logger can be switched off if a critical power level
has been reached. The following could occur:
- The logger continues to take readings although the display
indicates that the battery capacity is “empty”.
- The measuring program is stopped even though the battery
capacity display indicated a short time previously that
battery capacity was available.
Saved readings are not lost if the battery is spent or
changed. Requirement:
The battery is changed by following the directions in the
Instruction manual.
To Next Page
Loading...
Need help?
General
