EasyManuals Logo
Home>Texas Instruments>Desktop>990

Texas Instruments 990 Installation And Operation

Texas Instruments 990
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
JdlS\
______
_
~
945423-9701
includes
mounted
connectors and
is
used for
open
floor installations.
The
extension cable
kit
(Part
Number
936503)
provides cable and separate
connector
kits for final assembly
after
the
cable
has been
routed
through
the
walls
or
cable tray.
2.3 UNPACKING/PACKING
The display unit and keyboard are shipped in a corrugated
cardboard
container
system
as
illustrated
in figures 2-2 and 2-3. The VDT controller circuit
board
and
the
interconnecting cables
may
either
be packed in the accessory
box
shown in figure 2-3
or
in the
container
containing
the
computer
(if
the
terminal
is
shipped
as
a
part
of
a
computer
system). Upon receipt
of
the
container, inspect
it
to
ensure
that
no
signs
of
physical damage are present. Following this preliminary inspection, per-
form
the
following steps
to
remove the equipment from the
container
and prepare
it
for operation.
NOTE
Save
shipping carton and all packing materials for use in reshipment
of
the
unit.
1.
Position container so
that
the
address label
is
right-side up.
2.
Slit
tape
along
container
flag seams and open container.
3. Grasp accessory
box
by
its sides and lift
out
of
container.
4.
Open accessory box and remove contents, which
may
include manuals, VDT controller,
and interface cables, depending on configuration shipped.
5.
Set
contents
of
accessory
box
aside in a safe place.
6. Grasp
keyboard
box
by
its sides and lift
out
of
container.
7.
Open
keyboard
box.
8. Grasp
keyboard
by
front and rear edges and lift
keyboard
and
foam
end
caps
out
of
box.
9. Place keyboard and end caps on a table
or
other
supporting surface. Supporting key-
board from underneath, slip end caps off.
10.
Return
keyboard
end caps
to
keyboard
box
and set
box
aside.
11.
Lift
top
half
of
foam block
off
display assembly and set aside.
12. Grasp display assembly
by
front and rear where base
and
top
meet,
and lift
out
of
remain-
ing foam block.
Set display assembly in desired location.
13.
Return
all packing materials
to
boxes and repack boxes
into
shipping container. Store for
possible reshipment.
2-3
Digital Systems Division

Table of Contents

Other manuals for Texas Instruments 990

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Texas Instruments 990 and is the answer not in the manual?

Texas Instruments 990 Specifications

General IconGeneral
BrandTexas Instruments
Model990
CategoryDesktop
LanguageEnglish

Related product manuals