www.ti.com
ADS1256EVM-PDK Kit Operation
29
SBAU090E–November 2003–Revised November 2018
Submit Documentation Feedback
Copyright © 2003–2018, Texas Instruments Incorporated
ADS1256EVM and ADS1256EVM-PDK
Figure 27. Install New Driver Wizard Screen 5
5. Once Windows finishes installing the software driver, the plug-in downloads the firmware to the MMB0.
The status area will display Connected to EVM when the device is connected and ready to use. If the
firmware does not load properly, you can try resetting the MMB0 by pressing Reset and then reloading
the plug-in.
Verify the proper installation of the USBStyx driver using the Device Manager. Note that the first driver
item, NI-VISA USB Devices, disappears and a new item, LibUSB-Win32 Devices appears, as Figure 28
shows.
Figure 28. USBStyx Driver Verification Using Device Manager
The driver installation wizard sequence should not appear again, unless you connect the board to a
different USB port
To Next Page
Loading...
Need help?
General
