132 Chapter 3: Application Development Process
TI-83 Plus Developer Guide Third Release May 28, 2002
Next:
1. Click OK to exit the Edit Breakpoints dialog.
2. Select Debug, and then Go.
3. Click on the Πkey of the calculator. Note that the Status of the Debugger is
Running.
4. Click on the 2 key of the calculator. The status of the Debugger will change to Halted
when the breakpoint is reached.
Now:
1. Right Click on address line 4098 to bring up the breakpoints pop-up menu.
2. Select Set Breakpoint.
3. Select Debug, and then Go. The calculator display will be cleared and the
disassembly view will be updated to indicate that it is stopped at address 4098.
4. Select View, and then RAM to bring up the RAM view. In the Start Address field
enter OP1.
To Next Page
Loading...
Need help?
General
