O
PERATING
M
ANUAL
DAF380
M
OUNTING THE
M
ACHINE
ThyssenKrupp Aufzugswerke GmbH
5. Mounting the Machine
5.1 Erecting the Machine
The DAF380 machine is delivered fully mounted and aligned on the machine
base frame if the frame was ordered as an option (including rope pulley for
double wrap). The base frame is set up depending on the customer on the
machine room floor or directly in a cement floor.
In order to comply with regulations for noise abatement and sound
transmission, insulation elements are to be inserted between the frame
supports and the ground. These differ according to the type of mounting:
a) Rubber block 100 x 100 x 50 high without support
For mounting the machine on the machine room floor without a cement
floor or directly surface mounted on the cement floor.
b) Rubber block same as a) however with an additional base 140 x 140 x
80 mm high, for mounting on a cement floor, support cast in cement floor
(coating thickness
≤
60 mm). The support is also to be cemented in place.
The number of rubber elements and their arrangement is based on the total
load and the base frame type.
The required individual load on the supports should be between 7000 and
12,000 N / support.
On arrangement of the supports, it is to be taken into account that the overall
centre of gravity lies within the rubber elements. The number of rubber
elements is based on the total load.
See also Chapter 3.3.
You can find the versions and dimensions of the machine base frames in
Chapter 3.
To Next Page
Loading...
Need help?
General
